Innovative stem adopting the new design with flange type clamp to the handlebar and without stem cap. Tested for one year by Abel Mustieles .
Innovative stem adopting the new design with flange type clamp to the handlebar and without stem cap. Tested for a year by Abel Mustieles. 3D forged aluminum AK2014 stem, compatible with 31.8mm handlebars The new clamp consists of just two screws, it is attached to the body of the stem by two pins made of stainless steel. Inside it incorporates a groove to give more grip to the handlebar. Sold separately too. The stem cap has been fully integrated into the stem body, avoiding its use as a separate component. The use of this screw is simply to adjust the steering bearings. Common clip open at the front to the fork with one screw on each side. Both the upper and lower screws are metric 6 (M6). Handlebar clamp and fork are common M6x18mm, included. The integrated plug screw is also included. It is sent with a nice Clean packaging with the written measurement Stem with an angle of 27.8º and available in four sizes, 130.6mm, 141.6mm, 152.6mm and 163.6mm. Supplied with a black sand blasted anodized finish with HRNT CLEAN graphics, laser logos on the handlebar clamp. Weights (excluding screws): 130.6mm: 213g, 141.6mm: 220g, 152.6mm: 220g, 163.6mm: 225g